Type Parameter Values and Values Shown

[naughtyticklez]

I think there should be an option to type the value for some cell parameter instead of using the slider. It can get tedious trying to get the slider just right to get the desired value especially when you have big dumb fingers like me. This would also have the added benefit of being able to see a parameter value without having to change it, another thing I think the UI is lacking.

[Alast]

Yeah, this has been suggested many times. Unfortunately, it will most likely clutter up the UI and a good solution for it hasn't been found yet.

[H4yw1r3]

It should just remain as a tickable option in the Settings, like the Cell Types x Modes thing that Petter made.

EDIT: I think it's better if there's an option to replace sliders with a changable value instead of putting it beside the slider to avoid cluttering up the UI.

[naughtyticklez]

It should just remain as a tickable option in the Settings, like the Cell Types x Modes thing that Petter made.

EDIT: I think it's better if there's an option to replace sliders with a changable value instead of putting it beside the slider to avoid cluttering up the UI.

Ya that's what I was envisioning when I brought this up.